Ok I drew on paint of what I have, it's not very good but it gives a rough example.
I make a slice in the cable very close to the normal usb connector and expose wires... I see red, black, green and white. You want me to cut near the miniusb connector? If so where do I plug that to for recharging?
Add me on
kego6k@hotmail.com to further discuss.
edit: I think I understand you now... I chop off wire somewhere and usb side with normal usb and attatch by solder... I think i have min usb 4p and then it should work? Is there a way to make sure double check before soldering? Also I think I damaged a wire while peeling the black protective plastic. I thought I used otherside so I was careless. Can I use another miniusb cable? with small connector and normal 1?
Also how long do I cut the wire? In the middle? Another question can I sticky tape the wire to the back when not in use?