shiloh, you could try to extract your firmware , repair it then load it back on your player.
It could also be a fault in the radio chip on you board if so I do not think it can be fixed unless you can get a technician to replace it.

Re: DEAD PLAYER RECOVERY GUIDE
 

Hey boyz........

I'm havin few problems wit my player first of all its dead hence it want start.............

i tried the recover guide posted by xxxx

https://www.mympxplayer.com/viewtopic.php?t=567

and got half way thru and got this msg.........

"the file 'AdfuUd.sys' on USB mass storage device is needed"

can anyone help please.....

thank you for the guide
it functions perfect
first the firmware of the link dont serve but I upgrade before with a dump.bin of my firmware and PERFECT ALLL.............


THANK YOU
ps

excuseme for my english

cfbp, :) Glad you got your player going again, well done.

bmmsid, If you have MP3 Player Utilities installed there is a copy of th ADFU driver in RDisk Update\Driver folder.

Hi – Just got mine Mp3 4g from Wilson, it had ver 3.5.35 I wanted to update to ver 3.5.37.
The first one I tried did not update. The next one I downloaded – updated – but then I got A BLUE SCREEN I do have access to the chip (my files are still there) I did back up before I started.

When I try to use the upgrade tool - to upload the old firm ware, it says or " Device switching has failed, Reconnect device" or "Device not detected"

I just want to make sure before I start that, I have to go through the whole process of opening it up and touching the chip etc.

Please help.

markshmid1 : see all the recovery guide in the first page of this forum. is sure that you can recovery it ...

good luck

The question is do I have to open the gizmo up and short the chip to restart it? Or if i can go on to next step?

Thanks

Need Help!

I followed the steps of the recovery, all I get now is that sometimes Windows does not recognize the USB port (in the device manger it says “unknown device”) and in the firmware updater it says “device not detected”. I even formatted the drive and it did not help!

After rebooting the computer in the device manger it said “USB mass storage device” and when I ran the firmware updater it said “ Device switching failed, please reconnect device”

What do I do?

Help Needed.

After playing with the gizmo some more: I see that somehow there are two drives on the gizmo one is: 3.99GB and one is: 1M.
1 mp3 players were detected, 1 removable disks, 0 ADFU devices

Is it possible that this is the reason I am having trouble?