how to to the format correctly?
 

i have a dead player. how do i have to to the format correctly to put new firmware. If i try to to the full format it says me that "not supporting this type disk". and i have half memeory left of 4 gb.

how do i get rid of F disk what i even cant use beacouse i dont even have it.( i dont know how it got there)

and how can i change the G (disk for mp4 player) back to F again without loosing memory.

how do i get my memory back?

Re: how to to the format correctly?
 

Backup your data to another source before formatting.

Using the Disk Tool, go to the Partition and Encrypt tab and set the slider to maximum (ie right) 1st and format. You should be able to format it and avoid the error.
Now run Disk Tool again, go to the same Partition and Encrypt tab and set the slider to minumum (ie left) and format again. Now the additional F-drive would recombine into your original drive.

But be prepared as you might not get 4GB, seems like all 4GB players are hacked memory chips. My 4GB turned out to be 2GB.

Re: how to to the format correctly?
 

after doing the first format it made me one more disk for mp3/mp4 player H now i hava 2 of em

if i may find a right software then my player would work agaian after trasfereig it to my player?

dekart, Is your player working or dead. If your player is working go to the settings menu and make sure the "Online Mode" setting is set to "Normal Only" this should take care of the 2 drives you are seeing.

Re: how to to the format correctly?
 

I had the same problem last week of the 2 drives, setting to online mode only allowed windows to display as a single drive, but the memory itself still had that 2 partitions (actual and raw).

The process of formatting with the slider at max and then formatting the second time with the slider at min removes that raw drive without setting the online mode.

But i guess it doesn't really matter much since the raw drive is 0bytes anyway.

Re: how to to the format correctly?
 

I said in the first post that i have a dead player.

Hi every body
I have the same problem whith my digitalplayers
I have a nanoclone black 2Go
HY27UFO81G2M
ATJ2085H
the original firmware whose: ACT.V3.5.35 CM 60009V1-5K (08/19/2006).


By using a bad format (mp3players utility) i have lost all of 2Go abd now i have
just 109Mo ???
after i try to install a new firmware(full 3.5.35) and then my mp4 dont work, i
have a white screen(yes white screen)..............by using a firmwaremodify i
have used maxi contrast adjusting for having a few image the mp work now it's
detect by my pc but the screen is not very good, i have a bad image!!!

So what can i do for giving my 2Go and found the original firmware
(ACT.V3.5.35 CM 60009V1-5K (08/19/2006)....)