[solved] my player displays blue screen after upgrade

wiredcool24 · #1 (**permalink**) 12th Oct 2006, 2:04 am

Is it realy possible to upgrade a nano clone player coz as i read every topic in this furum...same topics where discus and yet the main problem remains unsolved. Now, my problem is that after i upgrade my unit, it only displays blue scree.. mp3 upgrade tools cannot detect my device but windows recognize it as mass storage device..... Pls! Help is badly needed.. thanks!

tadad1 · #2 (**permalink**) 12th Oct 2006, 4:34 pm

wiredcool24, You will need to follow the Dead Player Recovery Guide HERE to reset your player.

wiredcool24 · #3 (**permalink**) 12th Oct 2006, 9:16 pm

I already did... and my unit is recogniz as adfu or hs.. and as i run the mp3 ugrade tool..is says success but only the reading icon is desplayed.. nothing else. i tride to observe if its just reading and will eventually display its content but it didn't..just the blue screen and the reading icon in the center. tnx.

tadad1 · #4 (**permalink**) 12th Oct 2006, 9:43 pm

wiredcool24, The process of using the full version firmware is to get your player into a state where it will accept a standard backup dump. The chances that the full version firmware will recover your player on it's own are very slim. If your player will still not accept a backup dump I suggest you short the chip again and apply a different full version firmware then start uploading dump files till you find one that suits your player.

For one of my players I killed it 63 times before I found a suitable dump to recover it so be prepared to spend some time locating the right firmware for your player.

wiredcool24 · #5 (**permalink**) 12th Oct 2006, 11:46 pm

Ok. Thanks for a great advice. I'll do it. I'll post u a mssge as soon as i et my player working. Thanks once again!

wiredcool24 · #6 (**permalink**) 20th Oct 2006, 4:34 am

tadad 1 / admin... i would like to ask if there is any available pin configuration i can use for samsung 625 K9K8G08U0A in your possetion coz i need very badlly.. co'z everytime im upgrading my unit..ugrading tools always display " flash write protected"/"read write protect error".. can you help me with this problem? Help is very must appreciated. thanks in advance.. :cry:

tadad1 · #7 (**permalink**) 20th Oct 2006, 4:47 am

wiredcool24, Is your player visible in explorer or is it in ADFU recovery mode?

wiredcool24 · #8 (**permalink**) 20th Oct 2006, 10:50 pm

Yes it is, ans is recogniz as ADFU device..

wiredcool24 · #9 (**permalink**) 21st Oct 2006, 1:47 am

it display ether, "flash not responding" or "read or write information failed" what should i do now? help pls.

tadad1 · #10 (**permalink**) 21st Oct 2006, 3:18 am

wiredcool24, If your player is visible in Explorer you may need to format it. before it will accept the firmware.