HELP... I can't recover my dead player

sadclown · #1 (**permalink**) 22nd Jan 2007, 3:25 am

Guys can you kindly help me. i cant recover my dead player. i've tried thr dead recovery procedure here. at 1st attempt my player actually turns on. but after a while it turns off. and then on the second attempt to recover my player the player won't turn on. but i can hear a sound. a sound that when u put sa usb device on the computer when i'm trying to short circiut the player. But the computer cant recognize anything.What should i do?

tadad1 · #2 (**permalink**) 22nd Jan 2007, 4:24 am

sadclown, Is the player recognized by the firmware update tool?

sadclown · #3 (**permalink**) 22nd Jan 2007, 4:39 am

tada1

nope the firmware update tool can't recognize anything. what should i do?

lattesurf · #4 (**permalink**) 22nd Jan 2007, 6:06 am

sadclown , if the Upgrade Tool fails to detect your player, then you will need to repeat the Dead Player Recovery guide again by shorting the pins. And get your player back into ADFU state before trying another Full and Dump firmware.

sadclown · #5 (**permalink**) 23rd Jan 2007, 3:15 am

lattesurf

but even my computer can't detect a USB or ADFU.

Edwin · #6 (**permalink**) 23rd Jan 2007, 4:54 am

hey sadclown i have the same problem before.but i manage to solve it on my own

Try this one this might help you.

1. use different usb port. or unplug other usb device from your computer.

2. try to used different usb cable.because sometime even if you mp4 has been detected and charging on your computer when you try to recover a dead player using the usb cable you are using theirs a error message saying the usb usb is not properly connected.

3.if the computer manage to detect it install the device allow the computer to install and if the computer look for AdfuUd.sys try to find it at system32 on the WINDOS folder.

GOODLUCK nanlang sayo TOL sana gumana yan sayo!