dead player, no detection by computer
 

my friend found a mp4 nano clone and it doesn't work its a dead player he asked me to c if i could get it working. i connect it to my computer and nothing no detection.

and i was wondering if it is possible to put my mp4 firm wear and put it on his if i get the computer to detect it

could u list programs i might need to get it to work and to extract firmware

http://i118.photobucket.com/albums/o...2/mp4front.jpg
http://i118.photobucket.com/albums/o...den92/mp4s.jpg
http://i118.photobucket.com/albums/o...nden92/mp4.jpg
http://i118.photobucket.com/albums/o...den92/mp42.jpg

denden_oner , firstly you'll need to extract your friend's player firmware. The guide is here http://www.mympxplayer.org/how-to-ex...tool-vt66.html
However, the S1fwx v3.1 only support upto v9.0.43, so if your friend's player is higher, you can't extract a working firmware dump.

Next, you will need to perform Dead Player Recovery on the dead player. The guide is here http://www.mympxplayer.org/dead-play...ide-vt567.html

You will need to see the dead player's processor chip number. The ATJ2085 are using the v3.5.xx series, whilst the ATJ209* series are using the v9.0.xx series.
Depending on the chipset used, you'll need to find a suitable firmware in the downloads/firmware section.