player isn't showing anything after upgrade
 

i just succesfully upgraded my player

then

my player just shut down
after showing the message that it will now exit

then i turned it off and the main power then turn on again

the player isnt showing anything

but as i connect it to my pc its still recognized but my player is still not showing anything

well there should b a display that its connected to pc right??

where's the graphics?

It is quite clear that your attempt to upgrade your player was NOT successful. It looks like the same old story... the firmware you 'upgraded' with was incompatible.

Was there a problem with your player BEFORE you performed the upgrade?

Re: a little help pls
 

disk error...

think its the 5th time i have formatted it so decided to upgrad the firmware to .50 but that firmware sez that its the complete version...

any solutions ??

should i download s1fw tool first

i really dont know how to start over my player

yup back to square one...

pls teach me the step by step procedure..

You should never upgrade your player with any firmware unless you absolutely know what you're doing. As far as i know you cannot upgrade a player that was maybe fw9.0.48 or 9.0.43 or lower to 9.0.50

All versions are not compatible with all players. And a simple disk error would probably not warrant flashing the firmware.

s1fwx cannot extract versions 9.0.48 or 9.0.50 at the moment, you can try going to the download section and trying various firmware versions and flashing them to your player.. but i think in the end .. you're player is dead until they make a new version of s1fwx to extract 9.0.48 and 50

does that mean i cant use .43 version or bring it back to .48 version???

meaning theres just a little chance???

generally.. no

however you might get lucky.. no harm in giving it a try... download a .43 and try it... there is a .48 in the download section reserved for 'dead player recovery' only, might be your only chance.

should i download first the s1fw tool?? or whatever tool ??? : )

ill try .43 first....

can u help me step by step or should i do the same upgrading but with .43 version

tha s1fw is just for extraction right??

i have winrar... dat ok
??

Just do it the way you did it before.. by using the Mp3 Player Upgrade Tool. (if thats what you used)

S1fwx is useless to you right now. You don't need it. Can't use it because it can't extract .48 or .50

By the way.. formatting your player too often can cause problems. Once is usually enough.