Sunplus player not turning on and computer how recognising

[gorib65]

:cry: :cry: :cry: I have a Chinese sony mp5 Player, it has a 2 mega pixel camera. I do not find any board ID but below the LCD screen I Found This Number- DI 612-640226 06/16 20 FX020410DNSWBG01-02659, Chip- Sun Plus SPCA536A-HB111. Its firmware is damaged and it is not turning On. Computer is now showing Unknown Device .
I tried AdfuUpdate.inf from Windows Folder to run dead mp5 player as ADFU Recover Mode. But Windows does not take it and showing this messege
" The specified location does not contain information about your hardware". I am using windows XP service pack 2. What should I do now ? I need a
complete solution and driver for this mp5 player to run ADFU recover mode and a firmware for this player .

Shezan
Bangladesh.

[zrock]

gorib65,restart your computer.Then install the latest version of Mp3 Utilities that can be found at the download section.Then short again(if you have done already) the flash pins of your player.Then plug it on the computer then if asked for driver just use the RECOMMENDED option always and ignore the WINDOWS LOGO ERROR just continue.It should work now and your player will be on ADFU mode already.

[Zulu007]

First thing is that SUNPLUS-CHIPs dont run in ADFU mode .So make them run for software you have to put that mp4 or mp5 in the camera mode and what to do next..............the following is the link where you can get the information where you can get the information.
http://www.s1-mp3-player.org/category/sunplus-chip/
and for drivers you can search on the forum or on yahoo too