replacement switch for 1.5" nano look-alike

[000dreamsound000]

hi all
i lost the switch from my black 1.5" nano look-alike when i opened it to have a look at the memory chip.
any ideas as what to do to get a replacement or even an alternatime.

ps i got ripped off too was a 2gb instead of 4gb. will be adding ebay seller to Blacklist.

thanks for any help

[yogie]

hi 000dreamsound000

try h**p:\\www.globada.de

its a german website.

the first topic is about firmware versions etc.

the second topic is about spare parts . he's actually creating a webshop. so just drop him an email

the third topic is about repair service

hope this helps

cu yogie

[dannyboy]

:lol: I made a replacement out of a plastic lid after the power button broke on my player. Mine is a Nano clone with the switch on top. I cut out a rectangle with the width being the length of the original button. The length was 1 inch. The width was 1/2 inch. I folded it in half with pliers On one side I created a tab and folded it up to fit up through the case. Don't trim the ends. On the other side I cut a notch to fit the switch. I installed it in the player, then put on the silicone case. I then cut the tab just a bit higher than the case. My button matches the silicon case and is extremely durable.

[000dreamsound000]

Thanks a lot for all the help.
Much appreciated