display in mirror mode
 

hi,
i just update the firmware on my MP4 player, then now my display is in mirror mode and also has a big strip im the middle of the screen.
i don't know how to fix it. i did not backup the original firmware.

thank you for you help

Mike :(

Re: display in mirror mode
 

michaelkimmy2003 , the problem is that the firmware you flashed in is not compatible with your player.
There isin't a quick fix to it, you just need to try every firmware dump in the downloads section for your screen size until you get the right one. If the player goes dead in the process, then you will need to follow the Dead Player Recovery Guide Here.

thank you but now my computer can not detect it anymore. any suggestion.

thank you for your help

Re: display in mirror mode
 

michaelkimmy2003 , since now your computer cannot detect it, you will need to follow the Dead Player Recovery Guide process Here.

You will need to find a suitable Full firmware in the downloads section to flash it in first. Next, once successful, you can continue with the firmware dump testings.

Re: display in mirror mode
 

But, how can i download the image into the flash, my mp4 is not detectable.

could you help to fix it?

thank you

Re: display in mirror mode
 

michaelkimmy2003 , follow the Dead Player Recovery Guide. You need to short the pins to reset the chip. Then install the ADFU server, followed by the full and dump firmware.
Read the Dead Player Recovery Guide on how to do it. The whole process is a pictorial step-by-step guide.

thank you
i will try and let you know tomorrow,
do you know which pin?

Re: display in mirror mode
 

michaelkimmy2003 , there is no fixed set of pins to short. It is all a matter of trial & error, with a little bit of luck.