Hello everyone!!
I would like to know what happens to my FirmWare because this is what will appear if I extracted my firmware:
.................................................. ............
s1fwx v2.6 - copyright (c) 2005 wiRe (
http://www.s1mp3.de/)
dump s1 firmware from flash into file...
-------------------------------------------------------------------------------
NO WARRANTY NOTE
BECAUSE THE PROGRAM IS LICENSED FREE OF CHARGE, THERE IS NO WARRANTY FOR THE
PROGRAM, TO THE EXTENT PERMITTED BY APPLICABLE LAW. EXCEPT WHEN OTHERWISE
STATED IN WRITING THE COPYRIGHT HOLDERS AND/OR OTHER PARTIES PROVIDE THE
PROGRAM "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED,
INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND
PERFORMANCE OF THE PROGRAM IS WITH YOU. SHOULD THE PROGRAM CAUSE DAMAGE TO
ANY KIND OF DEVICE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR
OR CORRECTION.
IF YOU DONT AGREE TO THIS TERMS THEN PRESS ESC NOW!
-------------------------------------------------------------------------------
scan for devices...
detected drives: <f>
..<z> select device
<.> scan for devices
<?> display help
<~> exit program
$F
connect to device 'F:\'...
init device...
set device to f-mode...
get info from device...
device = 'LISONG MP3 Player'
manufacturer = 'Wilson Co. Ltd.'
firmware type = 'F285'
firmware version = 9.0.48
read boot record...
detect firmware size...
error: The system cannot read from the specified device.
warning: unknown firmware file
read flash...
error: The system cannot read from the specified device.
write to file 'dump.bin'...
---[ info ]--------------------------------------------------------------------
filename = 'dump.bin'
filetype = afi
md5 = 9EA9AEC26310943E6CC47E223C028365
---[ info:afi ]----------------------------------------------------------------
file id = 'AFI '
vendor id = 0x6977
product id = 0x6552
version = 9.0.48
date = 00/00/0000
+---filename---+ +---size---+ +-type-+ +---+ +--chksum--+
| BRECF285.BIN | | 16kb | | F285 | | B | | C557B73F |
| FWIMAGE.FW | | 6mb | | | | I | | 383F104C |
+--------------+ +----------+ +------+ +---+ +----------+
---[ info ]--------------------------------------------------------------------
filename = 'dump.bin.FWIMAGE.FW'
filetype = unknown
md5 = DA6A0D097E307AC52ED9B4AD551801FC
disconnect from device...
success.
Press any key to continue . . .
.................................................. .................................................. ...
My question is...Why is that there is only two filenames can be found in my firmware which is the "BRECF285.BIN" and "FWIMAGE.FW"..???
AND if I try to load it in a program-"s1res" an error message will appear...
"An attempt was made to load a program with an incorrect format"
why is that so??
and if there's a firmware just like mine....would you please email it here
titans_kill@yahoo.com
if you would mind.......PLZ.
"An attempt was made to load a program with an incorrec
